Napsal: 13 srp 2025, 19:00
Chcem ten heatspreader nalepit naspat (kedze tam je silikon, tak tiez silikonom), aby som mohol bez uprav a obav nasadit povodny chladic.
Najprv som to dokola obrezal spickou. Potom do vzniknutej medzery vlozil noz po celej dlzke jednej strany a naklepal ho tam kladivom. To som opakoval pre vsetky 4 strany a nakoniec sa to uvolnilo.
Pasta bola tvrda, tak som ju odstranil a dal tam MX-2 (mam tu celu tubu, tak to davam vsade). Na povodny cierny silikon som naniesol tenku vrstvu noveho (obycajny sanitarny), priplacol naspat. Hned som to osadil do dosky, dal pastu a nasadil chladic, nech to ma pri tuhnuti spravny pritlak.
Idle:
Kód: Vybrat vše
atk0110-acpi-0
Adapter: ACPI interface
Vcore Voltage: 1.17 V (min = +0.85 V, max = +1.60 V)
+3.3 Voltage: 3.38 V (min = +2.97 V, max = +3.63 V)
+5 Voltage: 5.05 V (min = +4.50 V, max = +5.50 V)
+12 Voltage: 12.53 V (min = +10.20 V, max = +13.80 V)
CPU FAN Speed: 2051 RPM (min = 800 RPM, max = 7200 RPM)
CPU Temperature: +31.0°C (high = +60.0°C, crit = +95.0°C)
MB Temperature: +37.0°C (high = +45.0°C, crit = +95.0°C)
k8temp-pci-00c3
Adapter: PCI adapter
Core0 Temp: +30.0°C
Core0 Temp: +27.0°C
Core1 Temp: +37.0°C
Core1 Temp: +31.0°CKód: Vybrat vše
atk0110-acpi-0
Adapter: ACPI interface
Vcore Voltage: 1.40 V (min = +0.85 V, max = +1.60 V)
+3.3 Voltage: 3.35 V (min = +2.97 V, max = +3.63 V)
+5 Voltage: 5.05 V (min = +4.50 V, max = +5.50 V)
+12 Voltage: 12.34 V (min = +10.20 V, max = +13.80 V)
CPU FAN Speed: 3125 RPM (min = 800 RPM, max = 7200 RPM)
CPU Temperature: +72.0°C (high = +60.0°C, crit = +95.0°C)
MB Temperature: +45.0°C (high = +45.0°C, crit = +95.0°C)
k8temp-pci-00c3
Adapter: PCI adapter
Core0 Temp: +67.0°C
Core0 Temp: +66.0°C
Core1 Temp: +65.0°C
Core1 Temp: +67.0°C