urc22c-15

[tibi]

zdravim! najde sa nahodou u niekoho manual na obsluhu aj stabulkou s kodmi zial mne sa to stratilo!

[tibi]

to naozaj nik nema toto dialkove?

[Smoldaa]

ja ti neco vygooglil
1. MANUAL SETTING

1. Look up the three-digitcode for your brand andtype of equipment in the Code Tables on the following pages.
2. Press the SET and Device Keywhich you want to control at the same time, then the indicator lights will turn on.
3. Press the three digit code for your equipement. Each time LED blink one time.
4. Press Device Key The activity indicator should flash, then turn off to indicate that
the code is accepted.
Note : If no Key on your remote is pressed for 10 seconds, the programming processwillstop automaticaly, and you will have to start over.

2. QUICK POWER SCAN(AUTO FIND) SETTING

1. Turn on equiment you want the remote to control, and point the remote toward it.
2. Press the SET Key and Device Key which you want to control at the same time, then the indicator lights will turn on.
3. Press the Set Key again, the indicator light will flash.
4. Press the POWERonce at a time(setup counter up) until, the equipment turns OFF.
5. Press the SET key to change the scan direction.
6. If equipment is turn off then press Device Key(any) then indicator should flash
and turn off toindicator that thecode is accepted.

Note : If no Key on your, remote is pressed for 30 seconds, the programing processwill stop automatically, and you will have to start over.
If the code is not match with your equipment, then repeat step 1->6.

3. nincs semmi...................

4. POWER SCAN CONCEPTS

1. Duning the power scan mode, if you press and hold POWER, the power code date is transmitted continuously.
2. During the power scan mode, if you press and release SET.
3. During the power scan mode, if you press and release Device Key, the current code data is selected.


CODE LIST

TV
300
301 Current Scanning Position
302
303

5. How to test the selected code ?

1. Press SET and digit, Led will be flashing. The flashing time is stand fot 1 st dight of the selected code.
E.g: Code=547 Led will be flashing 5 times.
2. Press SET and digit, Led will be flashing. The flashing time is stand fot 2 st dight of the selected code.
E.g: Code=547 Led will be flashing 4 times.
3. Press SET and digit, Led will be flashing. The flashing time is stand fot 3 st dight of the selected code.
E.g: Code=547 Led will be flashing 7 times.

[tibi]

dakujem za snahu hladat ale mna viac menej zaujima cast v ktored sa uvadza na aky typ tv npr philips aky kod mam zadat!